Dell Alienware m17 R2, Руководство по обслуживанию

Страница: 49 / 70

6. Lift the touchpad cable from the palm-rest assembly.
7. Remove the four (M2x2.5) screws that secure the touchpad to the palm-rest assembly.
8. Lift the touchpad off the palm-rest assembly.
Installing the touchpad
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the touchpad and provides a visual representation of the installation procedure.
Steps
1. Place the touchpad into the slot on the palm-rest assembly.
NOTE: Turn the computer over and open the display. Ensure that the touchpad is equally aligned along all four sides.
2. Replace the four (M2x2.5) screws that secure the touchpad to the palm-rest assembly.
3. Connect the touchpad cable to the touchpad and close the latch.
NOTE: This step is only applicable when the touchpad cable is not being replaced.
4. Fold down the keyboard cable.
5. Connect the keyboard cable to the keyboard-controller board and close the latch.
6. Connect the keyboard-controller board cable to the keyboard-controller board and close the latch.
Next steps
1. Install the
system board . (only applicable when the touchpad cable has been replaced)
2. Install the battery .
3. Install the rear I/O-cover .
4. Install the 2230 solid-state drive . (if applicable)
5. Install the 2280 solid-state drive . (if applicable)
6. Install the base cover .
49