Software User’s Manual
Rev 1.00
12
3
Command Line Interface (CLI) Reference
10GbE PTM management is done via the 10GbE PTM CLI. You can use the commands described
in this section after successfully connecting to the 10GbE PTM CLI according to the procedure
described in
Section 2, “Connecting to the 10GbE PTM CLI,” on page 8
.
3.1
CLI Privilege Levels
The 10GbE PTM supports the following user privilege levels:
• USER - Common user level, indicated by the # prompt
• ADMIN - Administrator level, indicated by the & prompt
Different commands are available in different privilege levels. The command reference indicates
the required privilege level for each command that requires a privilege level higher than USER.
3.2
Quick Reference
Table 5 provides a quick reference to the CLI commands:
Table 5 - List of Commands
Command name
Short Description
Reference
General Commands
help
Shows the list of available commands
Section 3.4.1, “help,” on page 13
exit
Exit from the 10GbE PTM CLI
Section 3.4.2, “exit,” on page 14
login
Change privilege level
Section 3.4.3, “login (ADMIN),” on
page 14
Software Image Commands
show image ver
Shows the software image version
Section 3.5.1, “show image ver,” on
page 14
copy image from-file
Upload new software image to the 10GbE PTM
Section 3.5.2, “copy image from-file,”
on page 15
Device Commands
show device temp
Shows the temperature of a specified device
Section 3.6.1, “show device temp
(ADMIN),” on page 15
Port Commands
show port link
Shows port link state
Section 3.7.1, “show port link,” on
page 16
