4. Hold the full-width wall-mount template to the wall and mark the screw-hole locations on the wall with the pencil.
Wall-mount dimensions
5. Drill eight 0.3 in (8 mm) holes in the wall at the pencil marks.
6. Install the eight wall-mount anchors into the holes.
7. Screw eight M5 screws into the wall-mount anchors leaving approximately 0.20 in (5 mm) gap between the anchor and the screw.
8. Slide the full-width switch onto the screws and tighten the screws to secure the switch in place.
Torque the screws to 24 in-lbs.
N3200-ON Series switch installation
21
