Removing the BOSS S2 controller card module
Prerequisites
1. Follow the safety guidelines listed in the
on page 26.
2. Follow the procedure listed in the
Before working inside your system
Steps
1. Pull and lift the BOSS S2 card carrier retention latch lock to open.
2. Slide the BOSS S2 card carrier out.
Figure 118. Removing the BOSS S2 card carrier
3. Using the Phillips #1 screwdriver remove the M3 x 0.05 x 4.5 mm screw that secures the M.2 SSD to the BOSS S2 card
carrier.
4. Slide the M.2 SSD out and up from the BOSS S2 card carrier.
Figure 119. Removing the M.2 SSD
5. Disconnect the BOSS power cable and the BOSS signal cable from the system board.
6. Using the Phillips #1 screwdriver remove the M3 x 0.05 x 4.5 mm screw that secures the BOSS S2 controller card module on
Riser 1. Slide the BOSS S2 controller card module towards the front of the chassis and lift the controller card module.
Installing and removing system components
139
Содержание E68S
Страница 19: ...Figure 14 Service information System overview 19 ...
Страница 59: ...Cable routing Figure 53 12x 3 5 inch Figure 54 8 x 3 5 inch Installing and removing system components 59 ...
Страница 61: ...Figure 57 24 x 2 5 inch with NVMe Figure 58 16 x 2 5 inch Installing and removing system components 61 ...
Страница 62: ...Figure 59 8 x 2 5 inch with NVMe Figure 60 8 x 2 5 inch with NVMe 62 Installing and removing system components ...
