Delem DA-66T, Справочное руководство

Страница: 117 / 218

V0913, 7.11
7.2.6. Corrections
In this view mode all corrections of all bends are shown. You can browse through all
corrections and change them as you see fit. If a correction for
α
1 is entered then this value is
copied to the correction for
α
2. Different corrections for
α
2 can be entered in the field itself.
The columns 'measured
α
1/
α
2' are present if they are enabled through the parameter 'angle
correction computation' in the Settings mode.
In the columns 'measured
α
1/
α
2' the real, measured angle of the completed bend can be
entered. On entry of this measured angle, the control will automatically compute a necessary
correction to reach the programmed angle. If there is already a correction present, the control
will adjust this correction to account for the latest discrepancy.
The column 'Stored correction' is only available when the Angle correction database has been
activated. When activated, the column 'Stored correction' shows for each bend the correction
value that is present in the database. A blank entry in this column means the database does
not have a correction value for this type of bend. When a new correction is entered, it will be
copied to the database automatically.
The markers '>' indicate bends that have the same value.
All From Stored serves to copy corrections in the database to the current program: corrections
in all bends are adjusted according to database values.
Axes corrections can also be edited in the main screen. When there are multiple axis available
this special view mode can be switched to for all axes corrections.