Delem DA-66T, Справочное руководство, Страница: 108 / 218

V0913, 7.2
The repetition of a bend and the connected programs, when applicable, are shown in the
header of the screen. A connected program is also indicated in the bend selectors last
position.
7.1.1. Auto mode, parameter explanation
Following is a list of the available parameters in Auto mode.
Corrections
Angle 1 / Angle 2
Corrections on angle values in this bending.
Angle corrections can be programmed for both sides of the machine, Y1 and Y2. When
correction Angle 1 is entered for one side, this value is automatically copied to the
correction Angle 2 for the other side. The correction for the other side can then be
changed. When both angle corrections have been entered, the resulting corrections for
Y-axis and parallelism are calculated. The corrections will be saved in the active
bending program.
The angle correction should be entered as following examples indicate:
Programmed value of 90 degrees.
Measured value of 92 degrees.
->
Then it is required to program of correction of -2.
Programmed value of 90 degrees.
Measured value of 88 degrees.
->
Then it is required to program a correction of +2.
In case the angle correction database has been switched on, the control checks whether a
correction exists for this type of bend in the database. The result of this check is prompted in
the entry field:
•
No stored correction.
No correction has been found for this bend
• Stored correction.
A correction that matches the current bend has been found
• Interpolated correction.
A correction has been calculated (interpolated) based on other existing corrections
If a correction is entered, it will be stored in the database. At each next bend with the same
properties, this same correction will be offered.
The angle correction database can be found on the Program Settings page in the Settings
mode.
Y1 / Y2
Corrections on the Y-axis positions, in case absolute programming is used or bottoming
is selected for a bend.
Auxiliary axis
Corrections on auxiliary axis positions in this bending. In case bend allowance is
activated (see the Settings mode) and a program has been entered in data preparation,
the X-axes correction values are the result of bend allowance calculation. The