Del ozone Z0-151, Руководство по установке и эксплуатации

Страница: 10 / 16

9
PERMANENT INSTALLATIONS
Figure 2: Standard Installation Diagram
SPAS AND POOLS
The Portable Purifier can be used on spas, hot tubs, and wading pools to
1,000 gallons, allowing you to reduce your chemical usage up to 90%. You
will never need to put up with dry skin, red eyes, faded suits, or green hair
again! Ozone is pH neutral, so it will not adversely affect the acid/alkaline
balance of your water. It is more cost effective than traditional chemicals
and leaves no undesirable smell or taste. Continuous operation is proven
to be the most economical treatment method for spa water, fountains and
larger bodies of water to 1,000 gallons.
1.The ZO-151 must be securely mounted to a clean surface and sheltered
from direct exposure to the elements (rain and water). Mount at least
five feet from the spa or water enclosure and at twelve inches above
the maximum water level. Ensure that the location is out of the reach
of children or anyone in the water.
2.To mount the ZO-151 Portable Purifier remove the two screws on the
unit cover and gently lift off the cover.
3.Using the four mounting holes in the corners, secure the ZO-151 Por-
table Purifier to the wall with screws. Spacer blocks may be necessary
for your particular installation. After mounting your Portable Purifier
reinstall the cover.
4.Connect the ozone supply tubing to the check valve on the left side of
the purifier. If the ozone supply tubing is too long, trim it with household
scissors or a razor knife. If the tubing is too short, additional ozone
supply tubing is available.
5.Place the dispersion stone into the body of water near the bottom
center for maximum ozone saturation in the water.
6.Plug the ZO-151 Portable Purifier into a Ground fault circuit interrupter
(G.F.C.l.) protected outlet.