36FB, 54FB
TURF BEAST
Rev: Mar2011
T
URF BEAST
Finish Mower
7
Assembly Instructions
Step 2: Mower Assembly Instructions
A. Attach handle bars using the upper hole
position setting. Using this hole position sets
the handle bars several inches lower. Use the
lower hole position raising the handle bar
location by several inches for comfort, if
necessary. These hole positions can also be
used for adjusting the handle bar location for
operators of different heights and arm lengths.
Select the height that is most comfortable for
you.
B. Reconnect the four (4) connecting rods from
the control panel to the chassis pivot points as
shown in the picture to the right. The rod
connections are secured with an initial preset
for the upper hole position (lower handle bar
position). If the lower hole position (upper
handle bar position) is used, the rod
connections must be adjusted.
C. Should the pivot ends on the connecting rods
be rotated during assembly, minor adjustments
may be required to achieve full travel on each
control handle. The control handles located
directly on top of the handle bars should
have full travel forward and stop
approximately 1/8-inch before the V-plate
strikes the handle bar. This positioning
provides full forward speed and the correct
restricted speed in reverse. Make minor
adjustments to the position of the threaded
connecting rod attachment to achieve this
control positioning.
1/8” gap in
full forward position
V-plates
