DEJELIN BO-WK2200BL, Руководство пользователя

Страница: 7 / 16

7
EN
1. The kettle is equipped with a removable
anti-scale filter (9). It stops potential scale
residues when you pour the water. Check
it is correctly placed before using the
appliance.
2. Fill the kettle up to the desired mark.
The water level indicator (6) indicates the
quantity of water in the kettle.
ADVISE
Oo obtain a precise temperature, fill with
minimum 350 ml water. However, you can
also use the appliance with less water.
3. Close the lid (2) with a simple press.
IMPORTANT NOTES
- Never fill the kettle through the spout (10).
- When filling the kettle, it is important to keep
the handle, the selection buttons (4a and 4b),
the ON/OFF and the display (3).
- Never exceed the maximum level (1,7L). Too
much water could lead to risks of projection
out of the kettle.
USE
4. Plug in the electrical cord.
5. Place the kettle on its power base (7). If the
temperature of the water is inferior to 30°C,
the indication <<--->> will appear on the
display (3).
6. With the help of the temperature selection
buttons ) and ( ) select the desired
temperature (from 50°C to 100°C by steps of
5°C). The selected temperature will appear
during 6 sec. maximum.
NOTE
Use the temperature button ( ) to
decrease the temperature compared
with the shown temperature or the
button ( ) to increase.
7. Within 6 seconds, press the ON/OFF
button (5) to start the heating cycle. You
will hear a sound signal, the indicator light
“ON/OFF” will automatically switch on.
As from 30°C the real temperature of the
water will appear on the display (3) and
will increase until the desired temperature
8. When the temperature is reached, a
sound signal will be heard. The function
“Keep Warm” automatically will activate
for 30 min. with possibility to change
the temperature around the selected
temperature. (cf. section “Keep Warm”
below).
9. After 30 minutes, the Keep Warm phase
will stop. All indicator lights will switch off.
Only the real temperature of the water
stays on the display (3).
10. Unplug the electrical cord.
NOTE
- At any moment during the heating
cycle, you can check the selected
temperature: shortly press the selection
buttons ( ) or ( ). The selected
temperature will flash on the display (3)
for a few seconds.
- When starting the appliance, some
water drops might appear on the power
base (7). This is completely normal. This
is condensed steam which forms when
starting the heating.