Deitz Pharmafill TC3, Руководство по эксплуатации

Страница: 60 / 84

Rev 2022-03-08 Pharmafill Model TC3 User Manual
Deitz Company Inc. TC3 User Manual Page 48
9.3 - Buildup Of Remove-To-Clean Contact Parts (Summary)
Use the pictures in section 9B – “Breakdown Of Remove-To-Clean Contact Parts (Illustrated)”
in reverse order to help with this procedure.
NOTE: The numbers in (parenthesis) below refer to the illustration in the next section.
1. Remove four screws and take off the Chip Chute Clear Cover. Clean out the Chip
Chute. (28)
2. Wipe clean the Feeder Chute in this position, or remove the two Feeder Chute
Mounting Screws and remove the Feed Chute. (27)
3. Remove the two
Sieve Mounting Knobs in the Feeder Chute . Remove the Feeder
Sieve . (26)
4. Tilt the Hopper forward and remove the
Hopper Door . The Hopper can be wiped
down in this position. (25)
5. Loosen the three
Hopper Mounting Screws . (24)
6. Remove the
Hopper Door Adjusting Knobs . (23)
7.
Backplate partially removed. (22)
8. Remove the
Back Plate . (21)
9. Remove the
Divider Flag and the Trap Flag . (20)
10. Remove the
Center Block . (19)
11. Remove The two
Side Blocks , one on the left and one on the right. They are identical
and interchangeable. (18)
12. Remove the Funnel Mounting Block . (17)
13. Remove the
Clear Front Cover . (16)
14. Remove the
Funnel Holder and the Funnel . (15)
15. Remove the
Counting Window and Counting Sensor as one unit. Do not disconnect
the fiber optic cables from the top of the Counting Sensor. (14)
16. Remove the Counting Sensor Cover . Slide the Counting Sensor to the right to
remove it from two the mounting pins. (13)