●
Writing the parameter and input and output values as you change them. To do this, open the
Parameter
page in
List
view. Double click on a parameter to open it. Change the parameter and click
Write
in the
parameter dialogue box.
●
Writing all the parameters in the utility software. Select
Parameters
, then
Write
(
). When you are on
the
Parameters
page, the write icon (
) is also available on the toolbar.
●
Writing information using the batch write function (
) (described below).
●
Restoring the controller information from a .bak file, using
Restore Device
.
Batch write function
If a CGC 200 file has been saved on the PC, it can be opened, edited and then written to one or more CGC
200s. To use the batch write function:
1. Click the batch read and write icon (
) on the toolbar.
2. Select
Write to device.
3. The Batch job (Writing) dialogue box opens.
Select the information that you would like to write and click
Run
.
5.3.5 Firmware upgrade
You can use the utility software to upgrade the firmware on the CGC 200.
To upgrade the firmware:
CGC 200 Operator's manual 4189340770
UK
Using the Utility Software
DEIF A/S
Page 39 of 43
