3.2.4 Viewing alarms
The
LED flashes when there is an alarm condition. You can see which alarm is present by looking at
the icons on the display.
3.2.5 Resetting alarms
To reset the alarms if there is a shutdown alarm, press
.
3.2.6 Stopping the genset
To stop the genset:
1. Make sure that the genset is in
Manual
mode.
●
If the genset is in Auto mode, press
.
2. Press
.
3.2.7 Adjusting and testing the display
The display light intensity can be adjusted by pressing
for more than five seconds. Keep pressing
until the light level (0 to 7) is right for you. 0 corresponds to the dimmest light, and 7 corresponds to the
brightest light.
You can test the LED lamps and display by pressing
for more than three seconds. If the LED lamps are
working correctly, these will all be lit. If the display is working correctly, it should look like the image below.
CGC 200 Operator's manual 4189340770
UK
Using the controller
DEIF A/S
Page 13 of 43
