4
5
6
3
1
1) Remove Transport Locks from the 2 Endwheel locations
and all Wing Beam connections (4-80’ or 8-100’/120’).
2) Slowly Back-up Strawmaster Assembly while extending
the Endwheel steering cylinder on
only one wing
to
spread the wing partially open to a minimum of 45°.
IMPORTANT:
To avoid contact of harrow sections
between the wings while unfolding.
3) When the fi rst wing has been unfolded a minimum of
45° or more (up to 90°), you can start extending the
Endwheel steering cylinder on the second wing.
Note: Ensure there is plenty of room behind and to the
sides of the Strawmaster before backing into fi eld position.
Important: To avoid contact
or damage, open
only one wing
a
minimum of
45°
(to
90°)
before
starting to open the second wing.
A
B
Connect Hydraulics
Backing Into Field Position
4) When the autofold swing arms are close to closing you can
activate the endwheel cylinder circuit again to open the
latch clamp.
5) When the swing arms are in position, this circuit can be
activated again (fully extended) to close the clamps.
Note:
If Latches have been left in the down position, the Swing
Arms can also be engaged by allowing the Swing Arms to ride
into the Latches and “click” into engagement.
Caution
:
Lock hydraulic functions for both wing circuits before
working in fi eld to avoid accidental operation while in use.
6) Lower the Harrow Sections down fully into fi eld position.
Adjustment Settings
- (refer to section “
C
”)
7) Adjust settings for light or aggressive harrowing.
8) Adjust Tine Angle as needed.
9) Adjust Parallel Angle as needed.
HARROW LIFT CIRCUIT...
Harrow Lift Cylinders
LEFT WING CIRCUIT........
Endwheel & Left Latch
RIGHT WING CIRCUIT......
Endwheel & Right Latch
3
2
1
2
2
1
1
1
1
1
1
1
1
3
3
7
2
Caution:
Before working in fi eld, lock the function for both the
Left and Right Wing Circuits to avoid accidental operation.
2
3
142647 v1.1
HYDRAULIC JACK CIRCUIT......
Jack Cylinder
4
QUICK-START GUIDE
*
for
STRAWMASTER
PRO
For Models with Serial Numbers 7557 and up.
* Refer to operators manual for complete safety and operation info.
TO
BE ELIGIBLE FO
R
YO
U M
UST REGISTE
R
WARRANTY
REMEMBER!
You must complete
Product
Registration
to be eligible for
Warranty.
