-5-
142646 - Strawmaster PRO (21-June-2018)
Although there are no operational restrictions on
the Strawmaster Pro when it is new, there are some
mechanical checks that must be done to ensure
the long term integrity of the unit. When using the
machine for the first time, follow this procedure:
IMPORTANT
:
It is important to follow the Break-In
procedures especially those listed in the “Before using”
section below to avoid damage:
A.
Before using:
1. Read Safety Info. & Operator’s Manual.
2. Complete steps in “Pre-Operation Checklist”.
3. Lubricate all grease points.
4. Check all bolt tightness.
B.
After operating for 2 hours:
1. Check all hardware. Tighten as required.
2. Check all hydraulic system connections.
Tighten if any are leaking.
C.
After operating for 8 hours:
1. Repeat Step B.
2. Re-torque all bolts on harrow sections and
mounting brackets.
3. Go to the service schedule as outlined in the
“Service & Maintenance” section.
BREAK-IN
Operation
Before operating the machine and each time there-
after, the following areas should be checked off:
Lubricate the machine per the schedule outlined in
the “Maintenance Schedule”.
Use only a tractor with adequate power to pull
the Strawmaster Pro under ordinary operating
conditions:
Minimum
80’ model:
450 HP
100’ model:
500 HP
120’ model:
550 HP
Ensure the Hitch Clevis is set at the correct height
for the tractor drawbar and trailer height.
Ensure that the machine is properly attached to
the tractor using a drawbar pin with provisions
for a mechanical retainer. Make sure that a
retainer such as a Klik pin is installed.
NOTE:
It is important to pin the draw bar in the
central location only.
Check tires and ensure that they are inflated to the
specified pressure. (
41 PSI/283 kPa
)
Ensure that a safety chain on the hitch is installed.
Check oil level in the tractor hydraulic reservoir.
Top up as required.
Check all bolt tightness.
Inspect all hydraulic lines, hoses, fittings and
couplers for tightness. Tighten if there are leaks.
Use a clean cloth to wipe any accumulated
dirt from the couplers before connecting to the
tractor’s hydraulic system.
Check all the machine settings, refer to the
Adjustment sections. Perform adjustments as
necessary.
Check tines, remove entangled debris. Replace
damaged tines. If tines are 20 in. or less in
length, they should be replaced.
(New tine length: 30 in.)
PRE-OPERATION CHECKLIST
It is important for both personal safety and
maintaining the good mechanical condition of
the machine that this pre-operational checklist be
followed.
OPERATING/MAINTENANCE SAFETY
• Read and understand the Operator’s Manual before
starting.
• Lower to ground, stop engine, place all controls
in neutral, set park brake and remove ignition key
before servicing, adjusting or repairing.
• Keep hands, feet, hair and clothing away from all
moving and/or rotating parts.
• Be careful when working around or maintaining a
high pressure hydraulic system. Wear the proper
hand and eye protection when searching for a pin
hole leak in a hose or fitting.
• Place safety stands or large blocks under the frame
before removing the tires or working beneath the
machine.
• Do not allow riders.
• Clear the area of all bystanders, especially children.
• Stay well back from machine when operating.
Keep others away.
