Page 11
3 Installation
Installation is the buyer’s responsibility. The
manufacturer accepts no liability for this service. Any
action that the manufacturer has to take as a result of
an erroneous installation will not be covered by the
warranty.
The necessary installation, including gas and
electrical connections, must be carried out by
qualified personnel in accordance with current and
local regulations. An installation by an unqualified
person may constitute a hazard.
Installations carried out by unauthorized persons will
void the warranty.
The manufacturer shall not be held responsible
for injury to persons or damages arising from
procedures carried out by unauthorized persons
or due to non compliance with these provisions.
Preparation of location and electrical and
gas installation for the appliance falls
under the customer’s responsibility.
DANGER
The appliance must be installed in
accordance with all local gas and/or
electrical regulations.
DANGER
Prior to installation, visually check if the
appliance has any defects on it. If so, do
not have it installed.
Damaged appliances are a safety risk.
This appliance requires an operating pressure of
2.8-3.0 kPa. A suitable LPG regulator that
complies with the requirements of SANS 1237
must be used.
The manufacturer and the seller do not accept
responsibility for any damage due to incorrect
installation or gas connection.
x
Gas bottles should be located outdoors in a
suitable ventilated lock-up.
x
The connecting hose should not exceed 125 cm in
length.
x
An appliance without a flame failure device may
only be used with a free standing cylinder placed
adjacent to but not closer than 300 mm to the
appliance.
Before installation
This appliance is designed for installation in a
domestic worktop. A safety distance must be left
between the appliance and the kitchen walls and
furniture. See figure overleaf (values in mm).
x
This appliance can also be used in a free standing
position. Allow a minimum distance of 750 mm
above the hob surface.
x
(*) If a cooker hood is to be installed above the
appliance, refer to the cooker hood manufacturers
instructions regarding installation height (min 650
mm)
x
Remove packaging materials and transport locks.
x
Surfaces, synthetic laminates and adhesives used
must be heat resistant (100 °C minimum).
x
The worktop must be aligned and fixed
horizontally.
x
Cut the aperture for the hob in the worktop as per
installation dimensions.
This appliance uses LPG (Liquid petroleum or
bottle gas)
