Page 13
Gas installation and connection
This appliance can only be installed and connected in
accordance with the statutory installation rules.
Room size
Ventilation
opening
Smaller than 5 m
3
min.
100
cm
2
5 m
3
to 10 m
3
min. 50 cm
2
Greater than 10 m
3
not
required
In the cellar or basement
min. 65 cm
2
DANGER Risk of explosion or
poisoning by unprofessional
installation.
The appliance may be connected to
the gas distribution system only by a
registered LPG installer.
DANGER Risk of explosion!
Before starting any work on the gas
installation, please shut off the gas
supply.
Gas adjustment conditions and values are stated
on labels (or on type label).
Your appliance is adjusted for LPG gas.
A stove without a flame failure device
may only be used with a free standing
cylinder placed adjacent to but not
closer to 300 mm to the stove.
Do not install the appliance next to
refrigerators or freezers. The heat
emitted by the appliance will lead to an
increased energy consumption of cooling
appliances.
Carry the appliance with at least two persons. The
appliance must be placed directly on the floor. It must
not be placed onto a base or a pedestal.
Material damage!
The door and/or handle must not be
used for lifting or moving the appliance.
Gas regulator
- Not supplied.
Range – 2.8 KPA SA5 regulator with a 2 meter hose
and 2 hose clamps.
Connecting the gas hose
Have your appliance connected so that it will be
close to the gas connection. Ensure that there is
no gas leakage.
Gas bottles should be located outdoors in a
suitable ventilated lock-up.
The connecting hose to be used must not be
longer than 200 cm in length.
Fit the clamp to the hose. Soak one end of the
hose (15 mm inner diameter) into hot water for 60
seconds to soften, then slip the softened end of
the hose completely onto the sharp hose tip of the
appliance.
Important information
Upon completion of the installation ensure that you
are familiar with the following:
a) The position of the isolation or shut-off valve in the
gas supply line to the appliance.
b) The requirements for safe operation of the
appliance
Note.This appliance is supplied ex-factory with
jets and air settings for use with LPG gas only.
Safety compliance with local requirements:
Installation
A stove without a flame failure device may only be
used with a free standing cylinder placed adjacent
to but not closer to 300 mm to the stove.
Ensure that pipe clamps are tightened correctly and
are of a good quality.
Flexible hose
Any hose that is used to connect the stove to the
gas system shall comply with SANS 1156-2 or BS
3212.
Gas cylinder
- Not supplied.
For best results we recommend that gas cylinders
with a minimum capacity of 9kg be used.
Regulator
- Not supplied.
A 2.8-3.0 kPa LPG gas regulator which complies
with SANS 1237 must be used.
Failure to comply with the above will render the
warranty invalid.
Note:
Your invoice is required in the event of you
wishing to make a warranty claim.
Where the appliance is intended to be permanently
installed, the installation shall only be carried out by a
registered installer and that such installations shall
comply with the requirements of SANS 10087-1or
SANS827 as applicable.
