more information visit our website at www.
definitivetech
.com
11
3. IR LEARN:
IR Learn is used to program SoloCinema Studio to respond
to other remote controls like your cable box or TV’s remote
IR commands.
IMPORTANT NOTE:
In some rare instances, a television may create
enough IR pollution to block the sound bar’s learning capability. Should
you experience this with your television, turn your TV on but leave the
source off. This should eliminate any IR pollution. The TV screen will
be black, but you will be able to work with IR LEARN OSD to program
commands.
Your bar can learn to respond to the following IR commands from other
remote controls:
1. POWER
2. VOLUME Up and Down
3. MUTE
4. INPUT SOURCE commands (up to six inputs).
The OSD is used to teach the remote commands to SoloCinema Studio
(see example below):
Important Note:
IR learn function should be completed within
3' of the sound bar. The accuracy decreases as you get further
away.
To learn your TV remote’s Volume UP command:
With the SoloCinema Studio powered on,
1.
Press the SoloCinema Studio remote control MENU button to
open the OSD
2. Scroll down to the third menu box: IR Learn
3. Click right arrow on the Studio remote directional control,
and VOLUME UP Illuminates
4. Press the Studio remote ENTER key.
Note:
You will see the words “PRESS & HOLD KEY”
displayed on the OSD.
5. Pick up the remote you wish to have the SoloCinema
Studio learn—for example, the TV remote. Press and
hold the Volume Up key
6. The words “PRESS & HOLD KEY” now change to say
“RELEASE.” Release the TV remote’s volume up key and
the OSD again prompts you to “PRESS & HOLD KEY.”
7.
The OSD will prompt you to PRESS & HOLD KEY three
times. The word “DONE” then appears on the lower right
hand corner of the OSD.
8. The OSD automatically navigates to STORE once the
3 press-and-release prompts have been completed.
9. Press the ENTER key while STORE is illuminated. The
menu now reverts back to highlighting the IR LEARN
function.
IR LEARN
Power
Store
Volume Up
Cancel
Volume Down
Clear All
Mute
HDMI 1
HDMI 2
HDMI 3
AUX 4
OPT 5
BT 6
4. SUB CONNECTION:
The SoloCinema Studio subwoofer and sound bar are paired at the
factory to communicate automatically. In rare instances, such as if
the original sub or bar are replaced, you must pair the subwoofer
with the bar:
1. Turn off the subwoofer and wait approximately
15 seconds
2. Select SUB CONNECTION and choose START PAIRING
3. Turn the subwoofer power ON
4. Wait until the green light appears on the subwoofer
amp panel
SUB CONNECTION
START PAIRING
5. SOLO SURROUND ARRAY (SSA) IMMERSION:
The MOVIE and MUSIC surround parameters are user-definable,
allowing you to customize the surround immersion intensity. Your room
configuration, main listening position, and personal taste can all affect
how much of the immersive sound experience you want. The MOVIE
AND MUSIC settings have a 21 position scale running from minus –10
to plus +10. They have been pre-set at the factory (MOVIE, +10 and
MUSIC, +5), and may need no adjustment. There is no “right” setting;
experiment if you wish, adjust to taste and choose the setting that
sounds best to you.
Please note:
Each time you want to use the MUSIC setting, you must
choose it by pushing the MUSIC button on the remote. The system
defaults to the MOVIE setting each time you select a new source. Input
#6 (Bluetooth
®
) defaults to music.
SSA IMMERSION
MOVIE MODE
MUSIC MODE
