TEX-BAR-MAN-15V05 (0903)
Copyright © 2015 Defi ne Instruments
12
6
INPUT SETUP & CALIBRATION
6.1 - Enter F1 PIN number
A
Enter the calibration mode by pressing the
button.
_ _ _ ENTER CAL PIN NUMBER
scrolls across the display and toggles with
0
.
Use the
and
buttons to enter your security code (factory default 1). Then
press
. If the correct PIN is entered, setup is started at 6.2.
If an incorrect PIN number is entered,
_ _ _ INCORRECT PIN NUMBER – ACCESS
DENIED
scrolls across the display and it returns to normal operating mode.
You will have the opportunity to change your PIN number at the end of this section
(6.8). If you have forgotten your PIN number, see Section 9.
6.2 - Input setup
A
_ _ _ INPUT SETUP
scrolls across the display and toggles with
SKIP
. Press
to
skip to 6.3, or the
button and then
to
ENTER
input setup.
B
_ _ _ MAINS FREQUENCY
scrolls across the display. Use the
and
buttons
to select
50HZ
or
60HZ
, and then press
.
C
_ _ _ INPUT MODE
scrolls across the display and toggles with the current selec-
tion. Use the
and
buttons to select:
4–20
(4–20mA),
0–20
(0–20mA),
2V
(0–2V) or
10V
(0–10V). Then press
.
Note that if you change the
INPUT MODE
in this step, then the input header on the analog
input module may also need to be changed. See Section 5 for more information.
D
_ _ _ DECIMAL POINT POSITION
scrolls across the display and toggles with the
current selection. Use the
and
buttons to select
NO DP
,
0.1
,
0.12
,
0.123
,
or
0.1234
, and then press
to accept and continue.
E
_ _ _ DISPLAY ROUNDING
scrolls across the display and toggles with the select-
ed rounding. Using the
and
buttons, select:
NONE
,
2
,
5
, or
10
. Press
.
