DeFelsko PosiTest HHD, Инструкция по эксплуатации, Страница: 7 / 72

5
Quick Start
The
PosiTest HHD
powers-up when the power button is
pressed. To preserve battery life, it powers-down after
approximately 5 minutes of no activity. Alternatively, select from
the menu for immediate power-down. All settings are retained.
1. Review
Operational Safety
(pg. 2)
2. Assemble the detector for the application to be tested –
“Assembly Instructions”
(pg. 5).
3. Properly ground the instrument –
“Grounding”
(pg. 6).
4. Set the test voltage –
“Adjusting the Test Voltage”
(pg. 7).
5. Confirm that the detector is in proper working condition –
“Operational Check”
(pg. 6).
6. Perform the test –
“Instrument Operation”
(pg. 9).
Assembly Instructions
STEP 1. Attach the Extension Rod:
Press and hold the lock gate
button while inserting the rod. Ensure the anti-rotation tab on the rod
is aligned with the corresponding receptacle on the
PosiTest HHD
.
Release the lock gate button and ensure the rod is securely
attached.
STEP 2. Attach the Electrode:
Loosen the thumb screw on the free
end of the extension rod, attach the required electrode (or adaptor),
and re-tighten the thumb screw.
STEP 3. Attach the Ground Cable:
Align the flat side of the cable
connector pin with the alignment mark in the ground cable socket on
the detector, insert fully and rotate the connector clockwise 180° to
secure the cable. Rotate the cable connector 180° counter-
clockwise to unlock and remove the ground cable. (see
“Grounding”
pg. 6)
STEP 4. Attach the Shoulder Strap:
Clip the strap to the strap
attachment points.
STEP 5. Install the Battery:
Loosen the screw on the battery
compartment and remove the cover. Install the battery in the correct
orientation. Replace the cover and secure with the screw.