DEFA 820x, Руководство пользователя

Страница: 27 / 29

GB
24
Panic function
To turn the panic function on, press on the A and B buttons on the remote control at the same time, and
keep them depressed. The indicators will again flash, and the alarm siren sound, as long as you keep
pressing the buttons (default setting).
Functional testing of the Alarm Module
The Alarm Module must be controlled at regular bases to verify the function.
Procedure for function test:
- Turn the ignition on.
- Open one door at the time and check that the LED flashes rapidly.
- Open the hood and luggage compartment and check that the LED flashes rapidly.
- Turn off the Ignition.
- Press button A and B on the DEFA Remote Control at the same time, keep them
pressed until the siren and flashlights are activated.
- Turn the Alarm Module ON (arm). Knock carefully on the front window of the car with a
coin, key or similar, and verify the response from the Glassbreakage sensor in the flashing
light and siren.
- Turn the Alarm Module OFF (disarm)
If the functional testing discovers any faults, please contact your nearest DEFA dealer to correct it.
Coding new DEFA Remote Controls
--- For more information, contact an authorised DEFA dealer
A. One short press on button B to turn off the alarm and immobilizer (if fitted). Emergency
disconnection can also be used.
B. Turn the ignition on and off 5 times in succession. The LED flashes rapidly when the
ignition is turned off the fifth time.
C. When you turn the ignition ON again, the LED should flash. Let the LED flash just as
many times as the first digit in your PIN code, and turn off the ignition (the LED stops
flashing).
D. Turn the ignition ON again and repeat the procedure until you have been through all of
the digits in the PIN code.
E. The LED flashes rapidly when the ignition is turned off after the correct PIN code has
been entered. If you make a mistake you can start from point C with the first digit in
your PIN code.
F. Turn the ignition on again, and press buttons A and B at the same time on the remote
control to be coded (one remote control at a time). Hold the buttons in until you have
received both light and sound receipt.
G. Turn off the ignition when all of the remote controls have been coded.
NOTE ! When you code the remote controls all of the old settings are deleted. You can code a
maximum of 4 remote controls.