DEFA 704924, Руководство пользователя

Страница: 6 / 32

6
ABOUT THE CHARGER
DEFA MultiCharger/MarineCharger/RescueCharger 1x35A and 2x35A are based on modern switch-mode technology and galvanized
divisions. These chargers represent the latest technology within battery charging and will give the batteries optimum life.
It is well suited to battery sizes up to approx. 600Ah and can maintenance charge the battery for an unlimited time. The charger
can stand parallel charging up to 20A parallel consumption at the same time as it charges the batteries. The charging voltage
is temperature compensated with external sensor. DEFA MultiCharger/MarineCharger/RescueCharger 2x35A has two separate
charge outputs and each output has a separate temperature sensor and remote LED.
To satisfy customers with different needs the charger comes without a fixed charging cable. This has to be obtained separately and
there are several different lengths available, as well as remote LED panel. See accessories list below.
AVAILABLE ACCESSORIES
Item number Name Item number Name
705294 5m Remote LED Panel 1x35 705099 2m Charge cable
705295 10m Remote LED Panel 1x35 705147 4m Charge cable
705296 20m Remote LED Panel 1x35 705159 6m Charge cable
705297 25m Remote LED Panel 1x35 705160 8m Charge cable
705162 5m Remote LED Panel 2x35 704924 Bracket 1x35A
705163 10m Remote LED Panel 2x35 704925 Bracket 2x35A
705164 20m Remote LED Panel 2x35
705165 25m Remote LED Panel 2x35
CHARGE PROCESS
See Picture on page 4. The Picture shows the charge process in a graph with Voltage (V) and Current (I) over time (t)
The LED on the front of the charger shows the charger status:
Green pulse – Charging
Solid green – Fully charged
Red pulse – Error
INSTALLATION
Read the user manual carefully. Wrong installation can result in damage to the equipment and possible injury. If there are any
uncertainties, please contact DEFA or a qualified person. Fix the charger properly where it is to be installed. See drill guide on page
4. Connect the charger according to the diagram on page 5. Connect red wire to (+) end black wire to (-) The charger is intended
for use with lead/acid, AGM and GEL batteries, but the battery manufacturers recommendations should always be taken into
consideration. The charger has to be installed with the connectors facing downwards to maintain IP rating 44.
NOTE: To make sure the correct charging voltages the charging cables must not we shortened or made longer
NOTE: Route the cables onto the contacts on the battery charger (Page 3, picture 1) so that they are straight, in order to prevent
the PlugIn contacts from being bent or twisted (Page 3, picture 2).
MAINTENANCE
The charger is maintenance free. All batteries should be inspected monthly as a minimum to achieve the best possible safety. The
charging process is in such way that the batteries remain fully charged without further water consumption than normal evaporation.