20181270 CR v8-2019Page 33
Remove the front panel of the appliance by following the instructions below:
a) Open the front blade of the indoor unit
(pivot it downwards)
b) As shown in the figures below, remove the
two protections on the front panel, then
remove the two retaining screws.
c) Pull the panel towards you to remove it.
Checking the water drainage
a) Place a container under the condensate
discharge
b) Check that the condensate discharge runs
through the appropriate hole.
Ductable indoor units (UGE):
Installation requirements:
Ensure that you respect the following installation requirements during installation.
Condensate
discharge
connection 2
Condensate
discharge
connection 1
Rubber cap
Retaining
screw
Retaining
screw
Front panel
Pull the front panel
on the fascia and remove it
Optional air
diffuser
