DeDietrich DTG 1138 Series, Руководство по установке и использованию

Страница: 47 / 168

47
CHANGING THE GAS SUPPLY
(CONTINUED)
•
Switching from natural gas to
butane/propane
C
HANGE THE INJECTORS
, proceeding as follows:
— Take off the grill, the cap, and the head of
the burner.
— Unscrew the central injector located at the
base of the burner unit Using a No.10 spanner,
(see
) and using a No. 7 spanner, unscrew
the 3 injectors located around the central
injector (see
) ( Fig.02).
— Replace with the new gas injectors; refer to
the injector positioning markers and the gas
settings table at the end of this chapter. The
new injectors should be fitted as follows:
— First , screw them in manually until hand
tight.
— Place the wrench on the injector.
— Turn the spanner clockwise .
— Replace the head of the burner, the cap and
the grill.
— Connect the power cable from your hob to
your single-phase mains supply (220-240 V
~
).
Refer to the section “Connecting to the
electricity supply”.
B
A
For the 1-burner hob
(high-power burner)
•
Note
Screw on the injector with a torque not
exceeding 4 N.m.
Exceeding this limit may damage the
product.
.
Tip
Each time you change the gas supply,
tick the box corresponding to the gas level
on the label found in the plastic bag.
See “Connecting to gas the supply”
Fig. 02
B
A
EN 2 / INSTALLING YOUR APPLIANCE
Y
OUR HOB IS NOW READY TO BE USED WITH BUTANE/PROPANE.