DeDietrich dpi7688xt, Руководство пользователя

Страница: 24 / 27

23
•
4
PROBLEMS
When using for the first time
You notice that something
appears in the display. This is
normal. It will disappear after 30
seconds.
The circuit breaker trips/blows a
fuse or only one side of the hob
works. The hob has been wired
incorrectly. Check the wiring (see
connections section).
The hob gives off a smell during
the first few uses. The appliance
is new. Heat each zone for half an
hour with a pan full of water.
When powering on
The hob does not operate and
the lights on the panel remain
off.
There is no power to the hob. The
electrical supply or the connection
are faulty. Inspect the fuses and
the circuit-breaker.
The hob does not work and
another message is displayed. The
electronic circuit does not operate
properly. Contact the After-Sales
Department.
The hob does not work, the
“bloc” information is displayed.
Unlock the child safety lock.
Fault code F9:
voltage less than
170 V.
Fault code F0:
temperature less
than 5°C.
During use:
The hob does not work. The
information is displayed and a
beep sounds.
There was a spillage or an object
obstructing the control panel.
Clean or remove the object and
continue cooking.
Code F7 is displayed.
The electronic circuits have
overheated (see 'building in'
section).
During the operation of a cooking
area, the illuminated symbols of
the control panel continue to
flash.
The pan being used is not suitable.
The cookware makes a noise and
your hob clicks during cooking
(see “Safety precautions and
recommendations”).
This is normal. With certain types
of pan, heat passing from the hob
to the pan causes this clicking.
The ventilation continues to
operate after the hob is switched
off.
This is normal. It helps cool the
electronics.
In the event of a persistent
malfunction.
Switch off your hob for 1 minute. If
the problem persists, contact the
After-Sales Department.
Sensor
A loss of communication of the
sensor may be caused by a weak
battery.
If is displayed: the sensor
is not paired or is switched off. If
the problem persists, check the
battery position.
If is displayed: the sensor
is already in use on another burner.
If is displayed + a BEEP:
The temperature measured is
incompatible with the selected
function. Check the suitability of
the chosen area and the selected
function.