14
FUNCTIONING OF THE APPARATUS
CONTROLS
(Fig. 18):
A = Light switch.
B = Motor ON/OFF - 1 speed switch
C = II speed switch
D = III speed switch
E = IV speed switch
F = Infrared beam sensor
Pressing once again the active speed switch in that moment, the timer making the apparatus stop automatically starts working
and the relative led starts to blink, this will last for 10’ then the motor will stop together with the lights (if they are ON).
In this 10’ time it is possible to change the motor speed. If you stop the motor you stop the counting.
At the end of 30 working hours, the light switch starts blinking to indicate that the anti-grease filter needs to be cleaned. To
reset press the speed switch that was working.
Remote control working
(Fig. 19):
G = Switch ON/OFF motor working at the same speed as when it had been turned OFF.
H = To increase speed
I = To lower speed
L = Light switch.
ATTENTION: the remote control needs a special care. Avoid it to come into contact with water and clean it
periodically in order to avoid any grease deposit. The remote control must be fed by a 9V, “Transistor” type
battery.
To get to the battery seat, pull the cover of the remote control (as indicated in Figure 20) making it slip towards the
outside.
Get rid of the empty batteries safely, using the appropriate containers. In case you would have to eliminate the remote
control, remember that you should first take the batteries off.
Fig. 18
Fig. 19
Fig. 20
E
D
C
B
A
F
G
H
I
L
