7
Step 8: Tighten all KD SCREWS.
FIREPLACE INSERT
INSTALLATION:
The fireplace insert can be installed after the
mantle has been fully assembled.
WARNING: Make sure the fireplace insert
controls are in the OFF position and the unit
is NOT plugged in.
Step 1: Place the INSERT on the floor,
behind the MANTLE. Carefully lift the insert
into the mantle opening until the top meets
the upper front panel. See fig. H
Step 2: Once the INSERT is in place, attach 2
MOUNTING BRACKETS (V) on the top of the
INSERT and lock the insert in place with 2
KD SCREWS (W). See fig. I
Step 3: Attach 4 MOUNTING BRACKETS (V)
to the bottom with 4 KD SCREWS (W).
See fig. I
Step 4: Move assembled unit to desired
location. Unit should not be positioned in
area exposed to direct sunlight.
WALL ANCHOR
SAFETY CABLE
The use of WALL ANCHOR SAFETY CABLE
is highly recommended in order to reduce
the risk of the fireplace being tipped over
accidentally. WARNING: This CABLE may
reduce possible risk of injury if the fireplace
is improperly handled, but is not a substi-
tute for proper adult supervision. Children
should not be left unattended near any
heater.
1. Drill a 5/16” (8mm) hole in the wall. Insert
the PLASTIC WALL ANCHOR into the hole
and gently tap until the flange on the anchor
is against the wall surface.
2. Position the back edge of the mantle close
to the wall.
A S S E M B LY I N S T R U C T I O N S
fig. H
fig. I
