52
5
5.6. Clutch Switch Adjustment
Be sure to perform the following adjustment
after replacing the clutch switch or shift plate 1.
D is co nn e c t th e clu tch s w i tch co u p l e r an d
connect it to a tester.
W h e n dim e nsi o n A (th e dis t an ce b e t we e n
shif t plate 1 and the seal plate) is changed,
the continuity of the clutch switch should be
as shown in the following table. Loosen the
screw, adjust the position of the adjuster plate,
and tighten the screw.
(A s yo u c h e c k f o r co n t i n u i t y, n o c h a n g e s
should occur when you shake shift plate 1 in
the direction of the wobble shown to the right.)
Dimension A
Clutch Switch Continuity
3.5 mm
Yes
4.5 mm
No
5.7. Controller Removal, Installation, and Position Adjustment
5.7.1. Standard
(1) Removal
(2) Installation
1 Loosen the 4 bolts indicated by the arrows.
2 Remove the controller.
1 Set the controller onto the upper holder.
2 Tighten the 4 bolts evenly.
Tightening torque: 6 to 8 Nm
Upper holder
