29
3
3 Connect the control unit according to the instructions in “(8) Connecting the Control
Unit and Lead Wires” in 3.4.
Secure the wire harness if necessary.
If the wire harness behind the seat back is not secured, the batter y may be posi-
tioned to the inside of the harness as shown in the “×” diagram (lower left) when the
wheelchair is folded.
If the wheelchair is unfolded in this condition, an excessive force will be applied to
the wire harness and the wire harness could be damaged.
When not secured
When secured
(7)
Wire Harness Routing for the Left Drive Unit (16"
Model)
1 Route the wire harness along the frame
and temporarily secure it using clamps.
2 Adjust the wire harness so that it will not
be pulled or become too slack.
3 Check that the wire harness is not pulled
when the frame is folded.
4 Use single edged nippers or a similar tool
to cut off the excess ends of clamps so
that the ends do not protrude.
5 Connect the control unit according to the
instructions in “(8) Connecting the Control
Unit and Lead Wires” in 3.4.
