Decko 24000-DKO, Руководство пользователя

Страница: 5 / 14

Part No. Name / Description Item
24935 Sprocket Cover 1
*
Sprocket and gear assembly 2
*
Chassis 3
*
Lamp plate 4
24905 Lamp Dome 5
*
Capacitor 6
*
Capacitor holder 7
8
*
Motor assembly
9
*
RPM wheel
10
*
Logic Board holder
11
*
Logic Board
12
*
Limit system driving gear
13
*
Limit system assembly
14 24937 Opener cover
Green
Screw
Gear
Close limit Contact
Open limit Contact
Center limit Contact
Red
Screw
Orange
Blue
Green
Limit System Assembly
1
2
3
4
5
6
7
8
9
11
10
12
13
14
Opener Assembly Parts
* Should be replaced by qualified technician only
24
Rail and Trolley Assembly
Opener
Trolley direction (Top View)
Clevis Pin
Pulley
Hitch Pin
Clevis Pin — 3/8” x 1-3/4”
Hitch Pin
Connect shaft to Trolley with “click”
To Assemble Rail and Opener
1. Prepare the rails as shown in Fig.1.
2. Connect the rails starting with the Header Segment. Insert
the tapered ends into open ends, apply any additional force
necessary by tapping the Rail on padded flooring. Ensure
the End Segment has Trolley Stop Bolt facing up. Make
sure the rails are securely joined together as shown.
3. Slide the Trolley onto the rail from the Header Segment.
Make sure the arrow is pointing towards the door as shown
in Fig.1.
4. Connect the rail assembly to the Rail Bracket on the Open-
er.
To Assemble the Header Section of Rail
Follow steps shown in Fig.2:
1. Remove the “Trolley Shaft and Cable” from the Chain carton
and lay it beside the rail assembly. Hold Cable Eyelet on the
end of cable and thread about 20” (50cm) through the slot
on the Header Segment of the rail.
2. Insert the Pulley into the opening while the cable is hanging.
3. Secure the Pulley by inserting the 3/8” x 1-3/4” Clevis Pin
through the top of the rail.
4. Lock the Clevis Pin with a Hitch Pin. Rotate the Pulley to
ensure it spins smoothly.
Refer to Fig.3 to connect the Trolley Shaft to the Trolley. Slide
both the Trolley Shaft and Trolley towards each other. A “click”
will be heard when they are connected.
To Link Cable with Chain
Refer to Fig.4. Place the chain carton beside the rail, hold the
“Chain to Cable Connector” and pull about 8” (20cm) of chain
from the box. Thread the Chain to Cable Connector onto the
Trolley Shaft so that they are loosely linked together.
Fig.1
Fig.2
Fig.4
Fig.3
!
CAUTION
- DO NOT connect power until instructed.
- To prevent INJURY, keep hands and fingers
away from joints and possible sharp edges.
- Wear gloves when installing chain and cable.
Rail Bracket
1
3
4
2
Trolley Shaft
Trolley Shaft Trolley
Cable Eyelet
Loosely link together
Trolley Shaft
Chain-to-Cable Connector
Chain
5
When connecting the rails ensure they are securely connected as shown above.
To apply additional force tap gently on the end of the rail with a rubber mallet*.
*Only use a soft rubber mallet to tap on the end of the rails as other tools may damage your rail.
Rail — Header Segment
Rail — Middle Segments
(tapered) x 3
Rail — End Segment (tapered)
with Trolley Stop Bolt