8-15-2018 K68622704
4
www.mopar.com
DR6 - 5’7” BED:
1)
Cut the tape into the following lengths for the 5’7” bed:
- 12” long - 2 strips
- 14” long - 4 strips
- 61” long - 2 strips
2)
Referencing the image
DR6
shown to the right:
a) Use isopropyl alcohol to clean the top surfaces of
the floor beads where the tape will be located.
b) Remove film from tape to expose the adhesive
surface.
c) Align the tape at the ends of the designated floor
beads, center the tape on the flat, top surfaces
and apply with pressure.
PREPARE BED:
INSTALL BED TAPE
NOTE: Got a spray-in bed liner, Bedrug or mat? You won’t need this bed tape. Otherwise, follow
the directions below depending on your bed length to protect your bed paint.
14” STRIPS
61” STRIPS
14” STRIPS
12” STRIPS
12” STRIPS
30” STRIPS
14” STRIPS
12” STRIPS
12” STRIPS
14” STRIPS
30” STRIPS
DR6
DR7
DR7 - 6’4” BED:
1)
Cut the tape into the following lengths for the 6’4” bed:
- 12” long - 2 strips
- 14” long - 4 strips
- 30” long - 4 strips
2)
Referencing the image
DR7
shown to the right:
a) Use isopropyl alcohol to clean the top surfaces of
the floor beads where the tape will be located.
b) Remove film from tape to expose the adhesive
surface.
c) Align the tape at the ends of the designated floor
beads, center the tape on the flat, top surfaces
and apply with pressure.
