8-15-2018 K68622704
6
www.mopar.com
C-CHANNELS C
ASSEMBLY:
DRIVER’S SIDE DECK
(LET’S DO THIS!)
• There are three pre-installed gaskets – one on the center vert, one on each underside of the decks where they rest
on the center vert. Do yours look weird? See them here:
DECKED.COM/GASKETS
• Place C-channel on the
inside
ledges of a cabside ammo can and a tailgate ammo can.
• The end of the C-channel with the endplate must rest on the cabside ammo can.
• Verify that the tailgate ammo can’s axle is closest to the tailgate; if not, grab the other tailgate ammo can.
• Install nylon washers onto all bolts in
BAG
C-CHANNELS C
.
• Loosely bolt C-channel to the two ammo cans with (4) nylon washers on the (4) bolts.
Make sure the bolt head is
on the C-channel side, not inside the ammo can
;
BAG
C-CHANNELS C
. Don’t tighten yet.
• Line up the driver’s side deck (sticker on end of deck panel indicates LEFT/DRIVER) on top of the
C-channel/ammo can assembly and the center vert bosses.
NOTE: Tailgate side of the center vert has an axle
installed; the center vert and ammo can axles must be on the tailgate end (not cabside end) of the assembly.
• Use
WASHERS
bag to install nylon & rubber washers on all
CS AMMO CAN
bolts. Install the same washers on 12
B1
bolts.
• Bolt the deck to the ammo cans;
BAG
B1
for the tailgate ammo can,
BAG
CS AMMO CAN
for the cabside ammo can.
•
Now go back and tighten the loose bolts connecting the ammo cans to the C-channel
.
• Bolt the deck to the center vert;
BAG
B1
(no washers):
Do not use power tools!
TAILGATE AMMO CAN AXLE
CABSIDE AMMO CAN
VERT AXLE
C-CHANNEL ENDPLATE
B1
DRIVER SIDE DECK HALF
➡
CAB
C-CHANNEL BAG
WASHERS BAG
NYLON WASHER
NYLON WASHER
RUBBER WASHER
CS AMMO CANS
B1
NO WASHERS
RECOMMENDED TORQUE:
Bolts in labeled bags
C-CHANNELS C, CS AMMO CAN and B1 - 27 in-lb.
