SI-3
™
U
ser
’s M
anual
11
connect” message in the status bar on the bottom of the window
you need to check your connections between the PC and the SI-
3™ .
4 . If SI-3™ Config is able to connect to the SI-3™, the screen
will appear as shown below in Figure 4 .2c . In this screen the
information that appears accurately depicts the present
configuration of the SI-3™ . Any changes made to the SI-3™
configuration are sent and stored in non-volatile memory . If
you turn off the SI-3™ unit while the SI-3™ Config program is
connected, just press the "
Disconnect"
button and reconnect .
Figure 4.2c
Connected
Any grayed-out box such as the serial number box is for reference
only and cannot be changed . The "
OK
" button sends an OK
command to the device which then responds with the message “OK” .
This feature can be used to check communication status at any time .
