Deagostini MODEL SPACE Lamborghini Countach LP 500S, Инструкция по сборке

Страница: 14 / 28

461
Lamborghini Countach LP 500S
This stage is now complete. You will finish
assembling your model in the following
stage, so make sure that you have all the
remaining parts prepared.
Extend the bonnet stay and align the
hole at the end of it with the circled hole
in the bonnet. Tighten a 1.7 × 4mm countersunk screw
(Stage 63) into the aligned holes of the
bonnet and the end of the stay. Don’t
tighten the screw too much, because if
you do so, the bonnet may not close.
Insert a 1.7 × 3mm screw into the hole
indicated in the inset. Tighten another three 1.7 × 3mm screws
into the three remaining holes in
the hinges. Align the holes in the bonnet hinges on
the bonnet with the holes and pins at the
front edge of the assembly. Tighten the screw into the hole.
39 40
36 38 35 37
If you have lost or misplaced
the 1.7 × 4mm countersunk
screw from Stage 63, you can
delay completing Steps 39 and 40
until Stage 80, when you will receive
another 1.7 × 4mm countersunk screw.
ATTENTION
STAGE COMPLETE