Dea SPACE, Инструкции по эксплуатации и предупреждения

Страница: 38 / 216

36
7 ADVANCED PROGRAMMING
Below find the description of some programming procedures relative to the management of the radio-commands memory and advan -
ced configuration of the command inputs .
To access the control unit advanced programming functions, remove the Jumper J4 from the board . Use the and keys to go to
P005 and hold the key down for 5 seconds (at this point, all of the parameters are visible and can be modified).
1 Visualisation of inputs and operations-counter status
1. Scroll the parameters with the and keys until the
screen reads P013;
2. Access the parameter by pressing the button;
3. The “Input Status” is shown on the screen (check that this
is correct):
4. Press the button again;
5. The “Total Operation Counter”
appears on the
screen followed by the multiplier.
To calculate the number of completed operations, the two
values must be multiplied.
I.e.: = 120x10 = 1200 operations completed
6. Press the button again;
7. The “Total Maintenance Counter”
appears on the
screen followed by the multiplier.
To calculate the number of operations remaining before
the maintenance request, the two values must be
multiplied.
I.e.: = 1500x1 = 1500 operations yet to be
completed before the maintenance request
8. Press the button again to exit the parameters (P013 is
shown on the screen again).
2 Selection type of operators
! IMPORTANT !
1. Scroll down the parameters with and keys until you visua -
lise P028;
2. Access the parameter by pressing the key;
3. Acting on and keys, set:
- d000 = SPACE
- d002 = SPACE XL
- d003 = SPACE XXL
4. Confirm your choice by pressing the key (display returns again
to P028).