16
5.4.9
Change ID
The Change ID (ID) command allows you to set/change both multiplexer
and port identifiers. Port IDs are entered in pairs, first drop, then host,
referenced to the local (Drop) port number. Pressing <Enter> with no
entry will leave the ID unchanged.
5.4.10 Show Map
The Show Map (SM) command shows the mapping and IDs of all drop
ports. If mapping for a particular port or range is desired, that port
number or range may be added to the command line.
5.4.11 Show Status
Show Status (SS) displays the status of the drop including number of
active ports and poll response time.
5.4.12 Show Network Configuration
The Show Network Config command (SN) displays the current network
port configuration (synchronous or asynchronous) and whether to use or
ignore modem DCD.
5.4.13 Change Network Configuration
The Change Network (CN) command is used to select half duplex or full
duplex operation. In full duplex mode there is an additional option to
ignore modem DCD. This is required in some multipoint radio
applications. The default is to use modem DCD.
If the multiplexer is set for asynchronous operation (see paragraph
4.1.1.1) this command is used to set the speed.
5.4.14 Activity Counts
The Activity Counts (AC) command shows the current statistics for all
ports. A range of ports may be included with this command to reduce
the number of ports shown.
The Z command is used to zero the counters so that current activity can
be monitored.
