15
NOTE
Several commands allow port numbers or port number
ranges to be included on the command line. When port
numbers are included, the syntax is as follows:
(Command)1
Port 1
(Command)1,2,6
Ports 1, 2 & 6
(Command)1 2 6
Ports 1, 2 & 6
(Command)2-6
Ports 2 thru 6
(Command)1,5-8
Ports 1 and 5 thru 8
5.4.5
Change Port Config
The Change Port Config (CP) command sets the local port loopback, flow
control and rate configuration. One or more ports may be set with a
single command by selecting a range of port numbers. The factory
default setting is Xon/Xoff Even, 9600 bps.
5.4.6
Remote Change Port Config
The Remote Change Port Config (RCP) command sets the remote port
configuration. This command requires a
local
(Drop) port number
argument. The multiplexer sends the configuration to the proper host
port number based on the system map. One or more ports may be set
with a single command by selecting a range of port numbers. The
syntax is the same as the CP command.
5.4.7
Change Delay Timeout
The Change Delay Timeout (CD) command is used to change three
timing parameters on the data ports.
Transmit data send timeout (0-250ms)
DCD to Receive data delay (0-250ms)
DCD holdover delay (0-250ms)
These parameters are set automatically depending on port speed and
should not require further adjustment.
5.4.8
Show ID
The Show ID (SI) command is used to view both multiplexer and port
identifiers.
