59
Router Module
The Router module lets you route a single signal or mono-summed signal to an input or output processing chain, see
‘Configuring Mixers/Routers’ on page 28
for diagrams and further information on available routing options. The graph
in the Router indicates signal levels, clipping, master gain fader position, and master mute status.
To edit a Router module:
1. Press the EDIT button.
2. Select a Router module using the
SELECT wheel and UP/DOWN
buttons. Press the SELECT wheel
to enter the module’s menu.
3. Use the SELECT wheel and UP/
DOWN buttons to navigate the
menu and edit parameters.
TIP:
When in a menu, pressing and holding the
EDIT
button for approximately 2 seconds will advance to the next module
below in the configuration map, wrapping around through the available modules. This allows quick navigation between menus
of a column and improves efficiency when performing repetitive tasks within like modules.
Router Parameters
•
MASTER GAIN
[-120dB - 6dB]
Adjusts the output gain of the Router.
•
MASTER MUTE
[ON, OFF]
Turns the master mute on and off. When this mute is on, an “X” will appear in the graph, indicating the master is muted
and no signal will pass from the Router module.
NOTE:
The front-panel Mix/Route meters monitor the signal level from the configured input Mixers/Routers. The
front-panel Mix/Route Mute buttons enable the “MASTER MUTE” parameters inside the configured input Mixers/Routers.
