15 / 20
FLYWHEEL BRAKE INSPECTION
1. Check to see if the inspection screw is contacting the brake bracket.
2. If the inspection screw is contacting the brake bracket, take the engine to an authorized engine
servicing dealer for flywheel brake pad inspection.
3. Release the starter control handle (located on equipment) and verify that there is a strong
resistance when pulling on the recoil starter. Also verify that the governor arm is moved to the
idle (slow), position and there is free play in the cable. The cable should 10-15 mm from the
centerline as shown when the cable is new.
4.Move the starter control handle(located on equipment) to release the flywheel brake, and verify
that there is clearance between the governor arm and the throttle return rod when the throttle
return rod when the throttle is in the fast (or high) position.
Also verify that there is at least 2 mm clearance between the stopper and the brake cable
bracket (see below).
8. Fuel tank
A: Fly wheel
B: Brake system
ENGINE ADJUSTMENTS
WARNING
Do not change in any way the rated speed of the engine (carburetor side or regulator side)
Your engine was adjusted in the factory and the non-respect of the homologation speed engine
could be dangerous for your safety and others safety. If the rated speed is changed in any way, the
factory warranty will be cancelled.
Brake cable
At least 2 mm clearance between the
stopper and the brake cable bracket
