•
Installation must comply with local plumbing codes.
•
Read these instructions for the dispenser and heating tank before proceeding.
•
Dispenser will drip occasionally in use after water is drawn and tank is heating more water. This is normal.
•
Make sure the tank outlet supply tube has no loops or low areas.
•
Tighten fitting with an adjustable crescent or open wrench. Never use a pipe wrench.
•
Never dispenser both hot and cold water at the same time.
•
Dispenser will occasional drip and spurt during heat up. Turning thermostat knob counter-clockwise little to prevent
spurting.
•
You will be instructed throughout this document to make certain of the position of the thermostat dial and references
will be made to various thermostat positions, such as "OFF“ , "MIN" , “MAX" etc. Please refer to the diagrams below to
understand the thermostat positions.
BEFORE YOU BEGIN INSTALLATION
1
The diagram right shows the
thermostat knob turned to its
lowest setting. To achieve this
position, turn the knob
completely counterclockwise
until it stops.
THERMOSTAT POSITIONS
Turn knob counterclockwise for
lowest setting position
Turn knob clockwise for maximum
hot water temperature
The diagram left shows the
thermostat at a Maximum
temperature, fully “ON” position.
Turn the knob completely
clockwise to achieve this position.
Lowest setting position
Low setting position
Maximum setting position
11
