13
14
Maintenance
Operation
1.Once you have using the machine, you are advised to turn off the water taps.(if necessary, pull out
the inlet hose)
2. Do not keep water in tub for a long time. When washing is finished , drain it right away.
3.Once you have finished using the machine, you are advised to unplug it.
4. Put the electric cable and the drain hose in order.
5. Wipe the water on the surface and in tub with soft cloth and keep the top lid opening for a while. It
helps to prevent mould and stagnant smells forming inside the appliance.
The machine stops automatically ,and music
buzzer will remind you to take out the laundries
or start again.
Once you have finished using the machine,
you are advised to unplug it and turn off the
water taps to avoid unexpected leak or fire.
After the end of the programme
Clean the exterior cabinet of the appliance with
soft cloth. Do not use cleanser, volatile chemical
materials to clean the machine, which will
damage plastic parts and the surface.
External cleaning
Clean inlet gate
It is possible that the inlet filter net can be blocked
by the dust, please clean it according to the follow
steps:
1. Close the tap and turn on the power switch.
2. Start the washing machine for 5 seconds(make
the water in the inlet hose flows to the tub),and
cut off the powersupply.
3. Pull off the inlet hose, remove and clean the inlet
valve and the inlet net, and install again.
Maint ena nce metho ds
If the water in the inner tub has possibility to freeze,please do like below:
1. In winter, if remaining water freeze can cause the washing machine trouble,
please take off the water inlet hose and drain out the water in the hose and inner
tub.
2. If the water freeze, please don't operate the washing machine. Put 40 hot water
in the tub, the hot water should submerge the pulsator, after a few minutes, rotate
the pulsator by hand gently, then you can operate the washing machine.
Magic filter cleaning
1. pull out magic filter
2. open the box and clean it
3. close it and reinstall it
4. check if the lint block part is in good condition
press this part and pull out to take
out the magic filter
lint block part (black rubber)
Troubleshooting
It does not drain
It does not inlet
Spin stops and begins to inlet
during spin program
Press the program button to
select SPIN, but It does not spin
The spin is intermittent when spin
starts
First time to use, some water flows
from the drainpipe
No water supply
Tap is not open
Inlet hose gets blocked
Laundries is too much or too little or the
Machine is not place stably
Before contacting the technicians, please make the following checks:
Control panel has no any display
Plug is not inserted tightly
No electricity in the socket
Power switch is not turned on
Power supply is cut off
Inlet hose leaks
Inlet hose connector(connecting with the tap)is not fixed tightly
Inlet hose and washing machine connector is loose
The remaining water when the factory make test
Do not close the top lid when drain is finished
Open up the top lid when start drain
Balance the laundries to reach to the best spin effect
Phenomena
Possible reason
Water outlet of drainpipe is higher than 1.2m
drainpipe is bended or get blocked