03
04
Any objects such as coins, safety pins, nails,screws, stones or any other hard, sharp material
can cause extensive damage and must not be placed into to the machine.
Before washing, please ensure the tap is open and the inlet hose is installed properly.
It is suggested to use low foam washing powder.
Do not put hands into the working machine.
It is dangerous even if the speed is very slow.
Take special care of the children, and forbid
them to climb on the washing machine.
It is dangerous to alter the specifications or
attempt to modify this product in any way.
Do not overload the appliance or put any hot
goods(such as the kettle with hot water)on the
washing machine.
Garments which have been in contact with
volatile petroleum products should not be
machine washed.
Keep the appliance away from direct
sunlight and heat sources like the heater.
Benzene
Petroleum
Thinner
Cautions
Before using
This appliance is not intended for use by persons(including children)
with reduced physical,sensory or mental capabilities,or lack of
experience and knowledge,unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with
the appliance.
Installation and adjustment
Before using
Loosen
Fasten
Adjustable
nut
Adjustable
foot
High
Low
Please install and adjust the machine according to the requirements of the manual.
It is very important to your safety and correct operation.
Unpacking
Unpack the carton and take out the bottom panel.
Open the top lid of washing machine and take out all of the accessories.
Remove all wrappers, including the polystyrene base.
You are advised to keep all the packaging for reuse in case the machine is to be
transported again.
Positioning
The distance between the washing machine and the wall should be more than 50mm, and the
maximum allowed angle of the shank base of the machine is 1 .The slanting or rough ground may
cause operating stopped or unstable, please adjust it with the following methods:
Horizontal checking
observe the water bubble in balancing apparatus
is in red circle or not. In red circle, it is horizontal
Adjust the adjustable foot
1 Lift up the adjustable foot gently, loose the adjustable nut
and twist the adjustable foot.
2 Fasten the nut after adjustment.
3 set the machine flat, and observe again. If the water bubble
is not in red circle, repeat the above procedure , till the water
bubble is in red circle
1
Installing the bottom cover
Let the back of washing machine incline forward make
the side of bottom cover with sticker description back to
washing machine insert to the bottom of washing machine
along the direction of arrow.
Remove two fixing clamp by scissors insert to the
accordingly holes red lines indicating gently pull
fixing clamp should not be pulled out
make the
bottom cover fixed on the base.
Fixing clamp
Scissors
Bottom cover
The base