2. Installation
2.1. Reviewing Defaults
The factory settings of your Dawicontrol Serial ATA Controller DC-154 RAID were
chosen to make modifications in jumper settings unnecessary in most cases. Yet prior
to installation you should verify that the jumper settings are in accordance with the
recommended defaults.
2.2. Installation
To install the DC-154 RAID Controller you will have to remove the cabinet of your
computer; please note the warranty agreement of your computer manufacturer. Before
removing the cabinet, always turn off and unplug your computer! The DC-154 RAID
Controller can be installed into any available bus master 32 bit 33/66 MHz PCI slot.
Illustration: DC-154 RAID
jumper ROM
controller BIOS
jumper set
on
no jumper set
off
(If you turn off the BIOS, the controller functions as a non-RAID controller.
A special non-RAID driver is required in this case.)
- 23 -
Manual
ENGLISH
