Page 6
Wireless Repeater
3. Apply power to the repeater.
✦
AC-Power Model
Plug the AC-power adapter into the jack marked POWER, and into an
AC-power outlet.Watch for the LEDs to light up (as described below).
A
PPLYING
P
OWER
TO
THE
AC-P
OWERED
R
EPEATER
✦
Solar-Power Model
Plug the power cord from the gel cell battery to the jack marked POWER
as shown below Watch for the LEDs to light up, (as described below).
A
PPLYING
P
OWER
TO
THE
S
OLAR
-P
OWERED
R
EPEATER
Both LEDs should flash once when power is applied. The repeater will per-
form a self-diagnostic that lasts about 7 seconds and then, if all is well, both
LEDs will flash again twice. After that second double-flash, the repeater
begins listening for a signal. If it finds one, the lower LED will flash as the
data is received and then the upper one will flash as the data is transmitted
out again.
If, one minute after the bootup, the repeater still cannot find a signal, it will
double-flash three times and then shut itself down in order to save power. If
this happens, check that your transmitter is transmitting and try reposition-
ing your repeater for better reception. Remove and reapply power to the
repeater to make it listen for the signal.
Repeater
AC Power Adapter
Power
Plug
Rechargeable
Gel Cell Battery
Repeater