Advanced Installations
Page 13
✦
Combo Network - Multiple Transmitters AND Multiple Repeaters
Any combination of the multiple transmitter network on page 12 and the
daisy-chain network on page 10. Notice in this example how the data all
flows in one direction; it enters the network at a point somewhere
upstream and exits the network somewhere downstream.
C
OMBO
N
ETWORK
- M
ULTIPLE
T
RANSMITTERS
AND
M
ULTIPLE
R
EPEATERS
Note:
No matter how closely they are spaced, no two repeaters should be listening to the same trans-
mitter directly–this only generates interference.
Setting up a Network
1. Set ID codes for each transmitter and receiver.
See your Wireless Weather Station or SensorLink manual for instructions on
how to set transmitter and receiver ID Codes.
2. Choose locations for the farthest transmitter, its repeater and its receiver.
Set the repeater to listen for that transmitter’s signal (see “Setting up the
Repeater” on page 3 for details). Make sure the repeater is receiving and
then re-transmitting the signal properly.
3. Add any additional repeaters as necessary, one at a time.
Make sure you set each one’s Repeater ID code (see “Setting the Repeater ID
Codes” on page 11 for details).
4. Put all the units in test mode to test the transmission of the data from the transmit-
ter, through each repeater, to the receiver.
Sensor Array/Transmitter
Console/Receiver
1
2
4
3
A
4
1
3
2
1
B
1
2
C
1
3
D
1
4
3
1
Repeaters
4
3
2
2
4
3
4
3
2
1