62 Maintenance
© Travis Industries
4140805
100-01384
DANGER HIGH VOLTAGE:
Disconnect power before attempting maintenance or repair.
Yearly Service Procedure
Failure to inspect and maintain the fireplace may lead to improper combustion and a potentially dangerous
situation. We recommend the following procedures be done by a qualified technician.
THIS FIREPLACE IS NOT USER SERVICEABLE:
Contact your dealer for servicing.
1. Inspect the pilot flame. It should touch approximately 3/8" of the top of the flame sensor. If it does not, contact
your dealer for service.
2. Shut off gas to the fireplace and let it cool for 15 minutes. Remove the glass (see page 54).
3. Remove crushed glass. If excessive sooting is found, the fireplace will require adjustment. Contact your dealer.
4. Inspect the burner and remove any debris.
Make sure the burner is not warped, cracked, or damaged.
Check the firebox and area around the pilot to make sure there is no warping or damage.
If any problem is found, discontinue use and contact your dealer for service.
5. Replace the crushed glass. Clean and replace the glass (see
Glass Cleaning
on page 62). If the glass is
damaged, replace. Make sure the gasket along the perimeter of the glass contacts the face of the firebox and
forms an air-tight seal. If it does not, re-align or replace the gasket to insure an air-tight seal.
6. Inspect the area behind the access door. Clean if necessary. Check the
gas control valve and the gas lines. If damage is found, discontinue use
and contact your dealer for service. Clean the air channels, ducts, and
blower (if applicable).
7. Start the main burner. After 15 minutes the flames should be
orange/yellow and not touch the top of the firebox. If the pilot or main
burners do not burn correctly, contact your dealer for service. Monitor
blower operation.
8. Remove any debris or vegetation near the vent termination. Contact your
dealer if any sooting or deterioration is found near the vent termination.
Glass Cleaning
The appliance must be completely cool
before cleaning the glass.
The glass may be cleaned with a non-
abrasive cleaner. To clean the inside of the
glass, remove the glass
, place it on a non-
scratching surface, and clean the inside surface.
WARNING
: do not operate the fireplace
without the glass in place.
Replacement Parts
Caution:
Use only Travis Industries replacement parts. Do not use substitute materials.
Warning:
Do not operate appliance with the glass front removed, cracked, or broken. Replacement of
the glass should be done by a licensed or qualified service person.
Contact your local Travis Industries Dealer for a Replacement Parts
