Davey SpaPOWER SP400P, Руководство пользователя

Страница: 5 / 12

5
To select the heating mode first press the Pump and Down buttons simultaneously to display the current
heating mode, then press and hold the Up or Down buttons to change modes.
3. PUMP OPERATION
There are four possible variations of pump 1 that may have been fitted to your spa, this user guide covers
all variations of pump 1 that could have been fitted. Please read sections 3.1 through to 3.4 then follow the
section which matches your spa operation.
Note: Even if a 24hr circulation pump is fitted there is no button to control it. The 24hr circulation pump
operation is completely automatic, It only turns off in sleep mode (if optional time clock is fitted) or in an error
condition.
3.1 Pump 1 (Single speed pump, no 24hr circulation pump fitted)
Pump 1 is controlled by just one touch pad button pushing the pump button three times cycles its operation
through three modes Automatic, Manual and Standby. When the spa is running in automatic mode, pressing
the pump button will deactivate auto mode and set the pump running in Manual Mode. The auto LED is
orange when auto mode is enabled and off when in Manual Mode. When the pump is in standby mode all
indicator LED’s are off.
Push 1 (Manual Mode)
Push 2 (Standby Mode)
Push 3 (Auto Mode)
Notes:
1) If Pump 1 is left in ”Manual or “Standby” modes it will automatically revert to “Auto” mode after 90 minutes.
2) There is no direct user control over the heater. The heater may come on automatically whenever Pump 1
is on.
3.2 Pump 1 (Single speed pump, 24hr circulation pump fitted)
Pushing the pump button two times turns the pump on and then off. The pump LED is green when the pump
is running and off when the pump is off.
Push 1 (Pump on)
Push 2 (Pump off)
Notes:
1) If Pump 1 is left on, it will automatically switch off after 20 minutes.
2) There is no direct user control over the heater. The heater may come on automatically whenever the 24hr
circulation pump is on.
3) If the heater element is on, running the pump may cause the heater to load shed and switch off. If this
occurs the heater will come back on approximately 5 seconds after the pump is deselected.