7
CONNECTING THE IN-LINE ELECTROLYTIC CELL FLOW SWITCH
TO THE POWER SUPPLY
Use the black & red terminals at base of the unit to connect the two wires from the Flow Switch
to the Power Supply (See below):
Place the Flow Switch wires into the terminal holes at right angles, and tighten the terminals.
CONNECTING THE FILTER CIRCULATION PUMP TO THE POWER SUPPLY
Insert the 3 pin male plug into the 3 pin female socket located at the bottom of the Power Supply.
See following diagram.
NOTE: Filter Circulation Pump current draw should not exceed 8 Amps.
Do not use a double adaptor to connect more than one pump –
it can cause overload to the system and could void your warranty.
