DATSUMO Labo Home Edition, Инструкция по эксплуатации

Страница: 11 / 20

Aftercare
Pressing the SHOT button will start the hair removal process. There are 2 types
of shot types to be chosen as shown below.
Basic Mode: Hair Removal per Shots
Place glass surface on skin and by pressing the SHOT button
once it will emit one shot. Afterwhich, move the glass surface
to another area and press the SHOT button again to emit
another shot.
READY LAMP
SHOT BUTTON
POWER BUTTON
Areas recommended for this mode for hair removal:
Underarms, knees, ankles, & small areas etc.
Continuous Shot Mode
Press and hold the SHOT button without releasing it.
Once the READY Lamp light indicator starts flickering
and the glass surface is in contact with skin, it will
automatically do continuous shots. This mode is
recommended for wider surface areas like legs so that you
can speedily complete the hair removal process. Slowly
slide over the area of intended hair removal as the shots are emitted.
Do not continuously irradiate the same area in one treatment.
When the glass surface is in continuous contact with skin for around 8
seconds, as a safety feature to avoid skin problems from double shots
the product will automatically stop shots from emitting. To resume
shots, lift the glass surface away from the skin for a moment and place
back against the skin.
Irradiated Area by Shot Light
Area of Shot Light
(Contact Area of Glass Surface)
Irradiation Area
Please ensure that you slide the product
glass area correctly so that leaves no gaps but does not overlap either.
When you are finished, press and hold the POWER button (for more than
2 seconds) turn off the power.
Make sure that the glass surface is not contaminated by dust or hair.
If your skin that underwent irradiation from the product feels hot and itchy
after using the product, use a cold, wet towel to cool down the skin.
Also, if you feel skin is dry, use a fragrance-free moisturizer to moisturize
the skin.