Datex-Ohmeda CAPNOMAC ULTIMA, Руководство по обслуживанию

Страница: 168 / 232

CAPNOMAC ULTIMA
TM
SERVICE MANUAL
8-2
PULSE OXIMETER
Connect the pulse oximeter probe to the monitor. The
message
‘NO PROBE’
is replaced by ‘PROBE OFF’.
Check that red light is emitted from the emitter, and the
probe surface is undamaged.
Attach the probe to your finger. Wait for the pulse search
to be done and readings to stabilize.
Verify that the PR and SpO
2
values are in the expected
range, and that the plethysmographic pulse wave is regular.
PRESSURE AND VOLUME
Verify that the D-LITE
TM
and the tubes are connected
correctly.
AGENT IDENTIFICATION
Feed calibration gas (p/n 755582) into the sampling line in
normal monitoring mode. If the message “CAL GAS
IDENTIFIED” comes up, the identification is functioning
properly. (Note:
ASX
softwares of level -1.0 and - 1.1 are
not capable to identify calibration gas R23 and the “MIXED
AGENT” message will appear instead of “CAL GAS
IDENTIFIED” message.)
8.2
Checks after component replacements
The following test should be performed after any service to ensure
proper operation of the monitor.
VISUAL INSPECTION
Constriction cassettes, water trap, oxygen measuring unit,
valves, and pump are connected with tubes in correct order.
Tubes are not clogged (no shape bends nor jams).
Tubes are not touching the pump or oxygen measuring unit.
Tubes are properly pushed in to the connectors.
Connect power cord and sampling line. Turn the power on and
wait until the initialization is over. Set the real time correct in
SETUP MONITOR
menu.
Check that no error messages are shown.
January l5th, 1997/6