CPU boards and softwares
Document No.8002948
9
9.
Check the loudspeaker volume settings by setting the alarm sound:
Alarms Setup
- Alarm Volume
Test the whole volume scale from 1 to 10 by turning the ComWheel and check that the
alarm volume changes correspondingly. The alarm sound should be clear and audible with
all the settings.
?
10.
Enter the service menu.
Monitor Setup
- Install/Service
(password 16-4-34)
- Service
(password 26-23-8)
Take down the information regarding the monitor software.
?
11.
Select SERVICE LOG from the menu. Record the Service Log onto the M-REC by selecting
RECORD LOG. Check the content of recording for possible problems, then empty the Service
Log by selecting RESET LOG from the menu.
?
12.
Test the Central Unit watchdog circuitry:
Monitor Setup - Install/Service
(password 16-4-34)
- Service
(password 26-23-8)
-
Set/Test -
Select the watchdog tests one by one and check that the monitor performs a restart in all
other cases except when selecting the
WD by UPI
.
NOTE: When selecting WD BY OVERLOAD, restarting should take place approximately after
15 seconds. With the other tests restarting takes place within a couple of seconds.
If restarting did not take place, try to locate the fault:
Watchdog --> CPU board/Power supply unit
WD by Overload --> CPU board
WD by GSP --> Primary display controller board/CPU board
?
13.
Check that the monitor is capable of storing the trend information and temporary settings in
a short (max. 15 minutes) standby.
Turn the monitor to standby and disconnect the power cord. Wait for two minutes, then
reconnect the power cord and turn the monitor back on. The monitor should perform a
“Warm start” which means the trend information and temporary settings should still be
available. If the monitor performed a “Cold start” instead, the battery fuse or the lead acid
battery of F-CU8 should be replaced.
NOTE: The B-CPU5/B-CPU4 requires 2 Amps battery fuse (P/N 51063).
The information regarding a start-up is also saved in the Service Log.
?
Содержание B-CPU4
Страница 2: ......
Страница 35: ...Appendix A CPU boards and softwares Document No 8002948 31 APPENDIX A ...
Страница 36: ...S 5 Anesthesia Monitor and S 5 Critical Care Monitor Document No 8002948 32 ...
Страница 38: ...S 5 Anesthesia Monitor and S 5 Critical Care Monitor Document No 8002948 A 2 ...
